Rc Lights

I have a Red One, a green one, I a great white, red / blue flashing light and a white and a small.

also where do I put them?

Installation: Use the glue model to hold in place if there is no hardware or media. Drill a pinhole size in the structure of thin son run the battery if it is used. The wiring must be pre-execution model. If not, then do not bother you could lose the model. By the way, fly an RC plane night has its challenges, not only losing sight of the model, but many obstacles are not lit.

light turns red wing tip left (port). Green light is on edge right (starboard). Left and right determined as if you were sitting in the driver's seat, impatiently.

A big white one is on the front of the nose.

The red / blue light is located under the fuselage, mid section (some people put on top, but it means that you can not see from the ground when checking it).

A small white goes on the tail.

DB did a great job covering all the points in detail, I would only suggest that you draw power from a separate battery aboard the R / C model and enable / disable a miniature servo and switch, using the One of the free channels on your radio. This will, apart from give you control of light, also prevent draining your battery.